I’m seeing too many standing seam clamps torqued by feel and failing spot checks; most specs I audit call 160–180 in-lb on set screws. Anyone running a compact digital torque adapter on the roof instead of a small click wrench that’s IP-rated and can export logs, so we can document conformance to the manufacturer sheet and meet audit expectations?
But i’ve been running the Milwaukee M12 digital torque wrench (3/8") with ONE‑KEY on S‑5! — I preset 170 in‑lb for the “160–180 in‑lb” spec and export a torque report, which beats arguing with a clicker and a clipboard. It’s not IP‑rated, so I use a simple rain sleeve; if you truly need an adapter, ACDelco’s ARM602‑3 is compact but doesn’t really log — would a full digital wrench still meet your audit plan?
I run the M12 3/8" with a 7/16" crowfoot to clear tall seams — 170 in‑lb, ONE‑KEY logging like @gabriella_92, and keep the crowfoot at 90° so “no correction needed”; only caveat is the head’s bulky under low ribs, so a stubby crowfoot helps. Do you mark each hit with Torque‑Seal for the photo log?